Readout definitions: more flexible averaging
You can now choose a different level of aggregation for each average readout, whereas previously the aggregation level was uniformly set for all readout definitions in the vault.
The available aggregation levels are as follows:
- Batch/Run is good for replicate data in a single experiment (run). Replicated data from the same batch of a molecule will be averaged together for each run of the protocol.
- Molecule/Protocol works well for generating summary results for molecules tested in a protocol. Data from all batches of a molecule will be averaged together across all runs of a protocol.
The calculation of averages is now a separate step: you have to create the readout definitions you want to average first, then click “add calculated readout definition”.
Once you've configured an average readout definition, you will see it listed right next to the corresponding non-averaged definition on the protocol page (below), in search results, and on the run page's data tab. Note that you can not yet average normalized or dose-response readout definitions.
Percent of negative control normalization for dose-response calculations
While positive controls are almost always a good idea, some assays are run without them. Until now, dose-response calculations required both a positive and a negative control if the raw data was to be automatically normalized within the CDD Vault. In this release you can normalize your dose-response data as percent of negative control. You will see the new option when you define a dose-response calculation in your protocol:
Molecule description has moved
The “description” field, which was previously part of the core molecule definition, is now just another user-defined field. If you had any data in the description field, it was automatically migrated.